#6AWG through 350kcmil
#12AWG through 2/0AWG
UL 467        NEC 250.8
Recognized for Grounding and Bonding
NEC 250.94
Intersystem Bonding Requirements
Residential • Commercial • Industrial
Made in the USA

The GND TerminatorTM and the GND Terminator JrTM provide a common point for the proper termination of up to six grounding and bonding conductors minimizing the risk of connection failure under ground fault and arc flash conditions.

Value with High Conductivity

With superior copper quality providing a conductivity level of 100%, these grounding bars assure a permanent, low impedance path for fault current. Aluminum has only 61% of the conductivity level of copper. The electrical grade copper GND TerminatorsTM come with silicon bronze hardware, thereby eliminating compression fittings with tools and dies and the increased labor associated with this type of installation. These grounding bars replace lugs which are often used but not generally listed for grounding and bonding.

Use with all electrical devices
requiring proper termination of grounding conductors.


SwitchboardsPanelboardsATS's
Disconnect SwitchesElectrical EnclosuresTransformers
Electrical EquipmentElectronic EquipmentPower Products


Improper Grounding has the highest sited violations under
OSHA 29 CFR 1910

The GND TerminatorTM and GND Terminator JrTM alleviate the confusion and guesswork in terminating multiple conductors. The GND TerminatorsTM provide a common grounding point with a single connection to earth, building steel, water pipe, and rebar.

The Superior Choice

Meet NEC Requirements •• Provide Common Grounding Point •• High Conductivity

Before and After Photos of proper grounding with the GND TerminatorTM:

Hover mouse over picture to enlarge.

     
More proper grounding photos of the GND TerminatorTM in use:

Hover mouse over picture to enlarge.

       
       
Photos of the GND Terminator JrTM in use according to NEC 250.8 and NEC 250.94:

Hover mouse over picture to enlarge.

Click to view NEC 250.94 Bonding For Other Systems